Calibrating Device Input Levels
Calibrating Input Voltage
- Warning: Before connecting anything to your audio device, make sure that it will not
send voltages into your device that are too high. Most audio input devices should handle
sinusoidal (single frequency) signal levels of up to 1 V peak, although the headset mic input
only accommodates input voltages of approximately 10-15 mV peak. It's best to start low and
increase input levels as necessary to avoid damaging your device.
- If you already know the voltage sensitivity of your input device (in V/FS), you can
enter it directly in the Input Sensitivity text box of the device calibration view and
skip the rest of the calibration procedure.
- Connect the output of an AC voltage reference generator to the first available input channel
of the current input device (headset or dock input).
- If you have a calibrated AC rms voltmeter
handy, you can produce the reference signal with IOScope's built-in tone generator.
In that case, you'll need to measure the output voltage with your voltmeter, so you know what
voltage you are applying to the input.
- Make sure the tone generator is turned on (in the Sig
Gen tab) before proceeding to the next step.
It might be a good idea to check the input signal in the
Oscilloscope display to be sure the signal looks good and that there is no visible distortion of
the waveform.
- Open the options view by tapping its icon in the toolbar.
- Tap I/O Device Options.
- In the top row of the Input Options table, make sure the desired input device is selected
(its name will be shown in parentheses).
- Make sure the Device Units selection is set to V (Volts).
- If you're using IOScope's built-in tone generator for a reference source, make sure
Audio Play Through is switched off.
- Tap Calibrate.
- The Calibration view displays the current measured input voltage as a text value as well as
in a horizontal bar meter. If the current measured input voltage agrees with the reference voltage
you have applied to the input (and there's no indication of input clipping), then you're done--your
input device already has the correct voltage sensitivity.
- Make sure your input is not clipping (you should not see the word "clip" displayed with
a red box around it in the upper left-hand corner of the screen).
If it is, you will need to decrease the voltage of your reference input signal. When the input
signal is no longer clipping, the red box around the word "clip" will disappear.
- Enter the rms voltage of the reference input signal into the Ref. Input Level text box.
- Click the Calibrate button.
- Confirm that you would like to Calibrate.
- Now check to see that the measured input level closely matches the level of the
reference signal. If it does, your device is properly calibrated.
- Clicking the Calibrate button causes IOScope to automatically calculate a proper
sensitivity (of volts relative to full scale input, or V/FS) for the input device, based
on the current measured input level and the Ref. Input Level value.